Step 1

starting point #1: First look is to the iso, (#3) who has 2-3 counts to cut, our reset is setup on the force side at a 45 behind the disc

Step 2

one fake...

Step 3

goal on the break side

Step 4

resetting... (starting point #2)

Step 5

if the iso catches the disc outside of the endzone on that same cut...

Step 6

#3 is now looking to the back of the stack for the continuation, #7 moved horizontally at first and had good spacing from #6 to avoid picks

Step 7

#7 catches the goal on the breakside (#2 is clearing up and eventually to the stack, #1 getting in position to be the reset on the force side)

Step 8

resetting... (starting point #3)

Step 9

if the iso does not get the disc...

Step 10

the thrower squares to their reset who is setting up/running the echo/blow by cut

Step 11

thrower seals the mark out and hits the reset running to the breakside

Step 12

If the reset clears the vert stack east to west, #7 is setting up the continuation to the breakside, while the iso (#3) clears to the middle of the stack and #4 moves up getting ready to become the next iso

Step 13

resetting... (starting point #4) - similar to #3 but not clearing the vert stack east to west

Step 14

fake...

Step 15

square to reset...

Step 16

the reset gets the disc but doesn't clear the stack east to west so iso clears towards the middle of the stack, #4 comes down to be the new iso and setup the continuation cut

Step 17

continue to #4 off the front, #1 clears up line and heads towards the middle of the stack, #7 setups the next continuation out of the back of the stack

Step 18

goal