Step 1

Up-line cut positioning

Step 2

Begin cut and pivot

Step 3

Change directions and make up-line cut

Step 4

Reset

Step 5

Dump cut. Begin cut and pivot

Step 6

Change directions and make dump cut

Step 7

Reset

Step 8

In cut. Cut hard to the cone and PIVOT (chop your steps or slow down to MAKE SURE THIS CUT IS A SHARP CUT WITH NO ROUNDING)

Step 9

Handler will pump fake to initiate change of direction. Handler should pump fake when the cutter reaches the cone

Step 10

Handler throws disc to cutter coming in. DO NOT THROW THE DISC UNTIL THE CUTTER HAS STARTED THE IN CUT

Step 11

Reset

Step 12

Deep cut

Step 13

Begin cut by cutting towards cone

Step 14

Cut deep and catch the disc