Step 1

Initial end zone set-up with the 2 handlers and the ONE (FRONT OF THE STACK) as an isolation cut

Step 2

The ONE will begin cutting when the handler (6) makes a pump fake and will ONLY CHANGE DIRECTION WHEN THE HANDLER PUMP FAKES (not when they think they should)

Step 3

ONE changes direction and receives the disc. The ONE will always become the new handler in the endzone offense (this means that only a HANDLER should be in the ONE position)

Step 4

The handler (6) who just threw to the ONE clears into the stack and 2 moves to the front of the stack as the new "ONE" (front of stack).

Step 5

The ONE (2) makes a cut, but is covered; so switches directions

Step 6

The one (2) then clears after switching direction. THE ONE IN THE STACK SHOULD ONLY MAKE 2 CUTS AND THEN CLEAR.

Step 7

New ONE sets up (6).

Step 8

The handler (1) turns to the dump

Step 9

The dump makes an up-line cut and scores