Step 1

Handler cuts - Jam cut. Handlers, remember to start your handler cuts at stall 4 or 5. If you have to, count the stalls in your head.

Step 2

If H2 cannot throw it to a cutter between stall 1 to stall 4, then start looking at the other handlers (H1 and H3) to pass it to them.

Step 3

At stall 3, stall 4, H1 makes a diagonal cut (45 degree, slash cut) in front of H2 towards the open side (aka, the force side). At the same time, H3 makes a dump slash cut (45 degree as well) behind H2. H2 can either throw it to H1 or throw it to H3.

Step 4

Try to reset back to a horizontal line like in step 1. H1 should be able to throw it to the cutters but if H1 can not, repeat steps 2 and 3.

Step 5

Step 6