Step 1

1. Setup

Step 2

2 cuts out to start, 3 cuts in to get the disk.

Step 3

1 cuts deep for 3. If it's not there, 2 cuts under for 3.

Step 4

4 cuts deep for 2. If it's not there, 1 cuts under into the wide open space. 3 also clears to the left to setup his next cut.

Step 5

4 makes an endzone break and/or hammer cut for 1. This cut is crucial because it clears space in the endzone on the open side.

Step 6

3 makes an upline cut into the endzone, and 1 puts the disc out to space in front of him to run onto. If this look is covered, 2 (or a handler) is the dump reset, and we transition to straight.