Step 1

Initial Setup - two cutting stacks, one at the front of the end zone, one at the back. Initial thrower upfield in space

Step 2

Cut from the back of the end zone stack to either side to initiate movement - cuts will alternate side to side after the initial cut. #1 throws to #5 near the corner cone

Step 3

Based on trajectory, the thower accelerates to one side of the receiver or the other to receive a dish pass. In this case, the throw was on the endzone side, so #1 should attack upfield space

Step 4

#5 follows the throw to complete a give-go motion, #2 begins their "v" cut. #1 clears to back stack

Step 5

#5 passes to #2 after receiving the give-go, then returns to the front stack. Drill repeats alternating sides with #6 cutting to right side cone

Step 6

in this example the disc went into the field side, so #2 should attack the inside angle for the dish

Step 7

Dish

Step 8

Give go, front stack activates

Step 9