Step 1

Set up with handlers in correct position and all cutters in a horizontal stack. Disc is in the middle. Outside cutters stay wide.

Step 2

The two middle cutters, 5 and 6, are active since the disc is in the middle. 5 slashes to the break side. 6 cuts out and back under on the open side.

Step 3

Pattern continues in this direction. Always slashing to the break-side, then cutting deep, and cutting under on the open side.

Step 4

Continue cutting pattern.

Step 5

Disc is reset to a side-line. 4 and 5 are active cutters and should take lots of space to cut. Inactive cutter, 6 and 7, need to give space to the active cutters by moving closer to the far sideline.

Step 6

Cutting pattern is the same for this cutting pair. Slash to the break-side, then cut deep to cut under on the open-side.

Step 7

Cutting pattern continues.

Step 8

Handler reset. Up-line cut, then cut back. Other handler is ready to be active.

Step 9

Reset to middle. Cutters finish pattern. Cutter 4 and 6 will now become active in the middle. 4 continues their slash to the break-side.

Step 10

Cutter 5 clears wide. Handler 3 is 45 degrees back.

Step 11

4 and 6 continue cutting pattern.

Step 12

Handler movement for reset.

Step 13

4 and 5 are inactive and need to stay wide. Also, cutters need to notice the disc is farther back and they should pull in. 6 and 7 are active.

Step 14

Cutting pattern begins.

Step 15

Cutting pattern continues.

Step 16