Step 1

Red is defense forcing forehand. Red pulls.

Step 2

Blue sets up Ho-Stack. Since we are talking about handler cuts, we will assume the disc is at stall 4 and needs to be reseted. Cutters may be involved, but are not the main source of resetting

Step 3

From the middle, Handler #5 is your first look for an easy breakthrow, but its very quick look and should not be forced.

Step 4

Back to mid, your second look is Handler #7 for a swing.

Step 5

Back to mid, three main things can happen to the handler #7 reset. 1. the poaching in the lane to block the throw to cutters. As handler #7 you can stay and receive the swing, or drag cut.

Step 6

Drag cut provides a breakthrow look to Handler #5. Handler #6 becomes side handler and Handler #7 becomes mid.

Step 7

Back to mid for the second situation, 2. if handler #7 takes the swing instead of the drag cut, handler #6 runs a strike cut (with 7 cut at the end =D) and handler #5 fills in and awaits reset.

Step 8

Continuation

Step 9

back to mid for third situation, 3. If handler #7 is guarded closely, you can chisel cut. If he doesn't follow immediately, a tight throw can be made..

Step 10

If the defended follows handler #7 hard, handler #7 cuts back.

Step 11

An option to continue this reset is to have handler #7 drag cut for a dump.

Step 12

If handler #7 is covered, handler #5 can strike cut and Cutter #1 can provide the breakside look. This happens after the drag cut from handler #7 has been acknowledged (2 stalls).

Step 13

Resets on forced sideline: YAY!! After the easy break glace (or super swing to handler #5), handler #6 can either strike cut into a 7 cut.

Step 14

or rail cut (just stopping your strike cut midway). Note: If the rail cut is unsuccessful, run strike.

Step 15

Back to forced side, when handler #6 strikes and doesn't rail cut, handler #5 can fill in and provide a second option.

Step 16

Continuation

Step 17

Break sideline resets are similar to the force side resets, but usually is an easy swing.

Step 18

Continuation

Step 19

Continuation

Step 20

Two more things (Not shown), 1. If a cutter catches a disc:, reset immediately if they are inexperienced (reset behind them). If they are experienced, treat them as a temporary handler, and have a handler clear into the cutter #1 spot temporarily. 2. When resetting, look and square up body with the resetting cut.