Step 1

set up

Step 2

Break side wing cutter will slash across while open side wing cutter will run deep towards the middle. cutter in the middle will clear towards the break side, prepare to set up for the continuation. Scenario 1: 4 gets the disc.

Step 3

7 will continue in cut while 6 sets up

Step 4

6 will come for in cut and 5 will finish or 6 finish at the deep.

Step 5

5 will finish if 6 didnt

Step 6

Scenario 2. after in cut fails.

Step 7

4 clears break, 7 comes in cut for disc. 6 sets up next cut.

Step 8

6 in cuts, 5 sets up, 4 clears back to the stack (if end zone, will be vert)

Step 9

4 clears back (cant do 2 animations so i added another step for this)

Step 10

5 finishes

Step 11

Scenario 3. If both in cut fails

Step 12

Handler will move to reset will mids also reset.

Step 13

if strike occurs, 5 will come for incut while 6 heads deep from the middle. 1 can look deep for 6 or look for 5 short

Step 14

if it hits 5

Step 15

6 will in cut, 7 sets up

Step 16

7 will finish or 4 will finish. It is the same cycle.

Step 17

reset to when both handler and mids are resetting

Step 18

if handler 3 gets it

Step 19

direct break side mid comes down

Step 20

4 will continue, 7 sets up, 6 resets to stack

Step 21

7 finishes.

Step 22

if its breakside, its free movement along break side until reset. hence any movement is fine as long as it is a clear and valid cut.

Step 23

Enter step description...

Step 24

Enter step description...

Step 25

Enter step description...

Step 26

Enter step description...

Step 27

Enter step description...

Step 28

Enter step description...

Step 29

Enter step description...

Step 30

Enter step description...

Step 31

Enter step description...