Step 1

Initial set-up

Step 2

First in line starts at cone 1

Step 3

Run to cone 2 and change direction (either cutting in or out)

Step 4

Thrower throws the disc to the cutter after he changes direction

Step 5

RESET

Step 6

Same thing for an in-cut

Step 7

*****SECOND VARIATION*****

Step 8

First in line starts at cone 1

Step 9

Run to cone 2 and change direction (either in cut or deep cut)

Step 10

THIS TIME, cutter will cut to either cone 3 or cone 4, break down their cut, and change direction

Step 11

THIS TIME, cutter will cut to either cone 3 or cone 4, break down their cut, and change direction

Step 12

THIS TIME, cutter will cut to either cone 3 or cone 4, break down their cut, and change direction

Step 13

THIS TIME, cutter will cut to either cone 3 or cone 4, break down their cut, and change direction

Step 14

THIS TIME, cutter will cut to either cone 3 or cone 4, break down their cut, and change direction

Step 15

****THIRD VARIATION****

Step 16

This variation is the same as the last one, ADDING a key component...THROWER INITIATED pump-fakes

Step 17

Cutter makes cut to either cone 3 or 4, MAINTAINING EYE CONTACT with the thrower

Step 18

As cutter is about to reach their cone for the change of direction cut, the thrower PUMP FAKES to initiate the change in direction

Step 19

Cutter then changes direction and catches disc

Step 20

Cutter goes to back of the line

Step 21

Next cutter steps up to cone 1